If you are a footwear professional, register or log in to find out our special conditions

MULTICOLLE

€34.13
Tax included

BASIS :
Grafted Polychloroprene cement for bonding all materials around shoes. Free of toluene and MEK.

Capacity :

Rating :  


MATERIALS :
All materials used for repairing and producing shoes and boots like leather, rubber, EVA, TR, felt, cork,
etc. can be bonded, even on plastified PVC (Vinyl). To stick PVC to PVC or bond natural rubber mix the
cement with 5-10 % Hardener =C=.
INSTRUCTIONS :
Grind all materials and coat them with MULTI-Colle until you can see a layer of cement. PE, PP: Contact
with an open gas flame. TR (Thermoplastic Rubber): Apply Renia-Rehagol and coat with MULTI-Colle
after 15 minutes. PUR (Polyurethane): After grinding, press the material together with paper to remove
the water. Then coat it with Renia-Primer for PUR to reinforce very soft Polyurethane. Apply the adhesive
without delay.
POT -LIFE :
4-6 hours if mixed with Hardener =C=.
OPEN ASSEMBLY TIME :
Depends on the material: 5 - 15 minutes (TR 2-10 minutes, PVC 5 - 20 minutes). MULTI-Colle can be
dried with an infra red lamp: IR-Lamp 80 °C: 3 minutes.
PRESSURE :
1-5 bar depending on the material
1 bar minimum time 60 seconds, 3 bar minimum time 15 seconds
The softer the material, the less pressure is needed. Caution: Do not deform materials during pressing,
otherwise the adhesive film will be destroyed.
HIGHLIGHTS :
Due to the fast crystallization and the high initial bonding strength of MULTI-Colle, it is possible to handle
the bonded pieces after a few minutes. The heat resistance is high enough to trim or buffer the sole or
heel. The bonding strength increases continuously and reaches its maximum after two days. Adding 5-
10% hardener greatly increases the resistance against heat, oil, and other chemical influences.

020010

Specific References

On Top
Menu
Close
Cart
Close
Back
Account
Close