COLLE DE COLOGNE

RENIA - Colle de Cologne - The Real “All Purpose“ Cement
Technical Data Sheet 110.000-0814
B ASIS :
Grafted Polychloroprene cement for bonding all materials around shoes. Free of toluene and MEK.
M ATERIALS :
All materials like leather, rubber, EVA, TR, felt, cork, fabrics, metal etc. can be bonded, even on plastified
PVC (Vinyl). To stick PVC to PVC or bond natural rubber mix the cement with 5-10 % Hardener =C=.
I NSTRUCTIONS :
Clean or grind all materials and coat them with Colle de Cologne until you can see a layer of cement. PE,
PP: Touch with an open gas flame. TR (Thermoplastic Rubber): Apply Renia - Rehagol and coat with
Colle de Cologne after 10-15 minutes. Expanded PUR (Polyurethane): After grinding, press the material
together with paper to remove the water, if necessary. Then coat it with Renia-Primer for PUR to
reinforce very soft polyurethane. Apply Colle de Cologne without delay.
P OT -L IFE :
4-6 hours if mixed with Hardener =C=.
O PEN ASSEMBLY T IME :
Depends on the material: 5 - 30 minutes (TR 3-15 minutes, PVC 10 - 45 minutes). Colle de Cologne can
be dried with an infrared lamp: IR-Lamp 80 °C: 3 minutes.
P RESSURE :
1 - 5 bar depending on the material
1 bar minimum time 60 seconds, 3 bar minimum time 15 seconds
The softer the material is the less pressure is needed. Caution: Do not deform materials during pressing,
otherwise the adhesive film will be destroyed. Flexible PVC or PUR can be pressed on by hand or with a
roller.
H IGHLIGHTS :
Due to the fast crystallisation and the high initial bonding strength of Colle de Cologne, it is possible to
handle the bonded pieces after a few minutes. The heat resistance is high enough to trim or buffer the
material. The bonding strength increases continuously during the first two days. Adding 5-10 % hardener
greatly increases the resistance against heat, oil and other chemical influences.
S HELF -L IFE :
Minimum 12 months at 20 °C
T HINNER :
RENIA - Schnellkleber-Verdünner (thinner) , no acetone!
C LEANING :
Clean equipment (glue-container, brush, etc.) with RENIA-Schnellkleber-Verdünner (thinner) or acetone
L ABELLING :
VbF : AI, Flashpoint less than 21 °C, highly flammable
GGVSEB : Class 3 Packing Group : III
IMDG : 3 UN : 1133
EmS : F-E, S-D